Dromenvanger van koord op metalen ring

1   Wind the yarn tightly all the way around the metal ring. Tie the two ends together with a knot when they meet.

2   Divide the ring, for example, into eight equal sections and make a small ball of cotton yarn. Tie the yarn at each point and weave from one point to the next.

3   Another example

4   Continue round the ring and work towards the middle, one section to the next in the middle of each string of yarn – under and over respectively. Remember to tighten as you go along.

5   Another example

6   Pull the yarn up in the middle, tie a knot and trim. A TIP: You may put a blob of glue onto the knot to make sure that the yarn end is kept in place.

7   Pendants on the dream catcher: Cut three pieces of yarn and tie them at three points between two sections. Thread a bead onto each piece of yarn and finish with 2-3 knots. Trim the excess ends.

8   Decorate the pendants. Push a blob of glue inside each bead and attach a feather inside the bead. Leave to dry. Hanging: Cut a piece of cord, tie it onto the top of the ring and thead on a bead.