Helsinki labelkaart

Helsinki labelkaart

Inspiration: 11257

Van: € 1,16

Tot: € 444,92

Prijs van het idee: € 0,00

Incl. BTW

Beschikbaarheid: Op voorraad

Van: € 1,16

Tot: € 444,92

Gemaakt van een stuk gevouwen papier. Gedecoreerd met brads en een geponste rand. Labels gemaakt van karton en gedecoreerd met papier en linten.

Guide step 1
1
Cut a piece of Vivi Gade Design paper from the series Helsinki size 28x28cm. Fold in half from the bottom up and open the paper again.
Guide step 2
2
Fold in half from the left to the right. Open the paper again.
Guide step 3
3
Klip i folden ind til midten som vist på foto.
Guide step 4
4
Make a fold in the lower right corner. The length is 8cm.
Guide step 5
5
Make a fold in the upper left corner. The length is 12x12cm.
Guide step 6
6
In the lower right corner attach double-sided adhesive pre-cut strips as shown.
Guide step 7
7
Close.
Guide step 8
8
Also, attach double-sided adhesive pre-cut strips on the top left corner as shown in the photo.
Guide step 9
9
Close.
Guide step 10
10
Put on double-sided adhesive pre-cut strips as shown on the photo.
Guide step 11
11
Fold over towards the left and press down the side firmly.
Guide step 12
12
Punch a border, 16cm in length, from green design card and insert a satin ribbon.
Guide step 13
13
Secure the ribbon onto the border with E-Z runner tape. A small strip is enough to keep it in place.
Guide step 14
14
Put tape onto the back of the border in the same manner as shown in the photo.
Guide step 15
15
Place the paper so that it is turned as shown in photo.
Guide step 16
16
Attach the border onto the edge and decorate with brads. Make a small hole with an art knife, attach the brad and and push the legs out to each side on the back.
Guide step 17
17
Turn the paper and attach the tape as shown in the photo.
Guide step 18
18
Fold up the bottom left flap. (This is now the back of the front).
Guide step 19
19
Close.
Guide step 20
20
Cut a piece of green design card measuring 13x13cm and punch a border along one side. Attach white design card behind it so that a small edge peeps through. Then glue this onto the innerside of the card in order to stiffen the side and in order have a clean area to write on.
Guide step 21
21
Make two tags for the pockets. These measure 6x17cm. Cut off the corners and make hole for a ribbon and fold 6cm from the bottom edge.
Guide step 22
22
Tear off the top edge, so you can see the white core of the paper. Tear 2 strips of paper and glue them on underneath. Cut off excess paper along the edge.
Guide step 23
23
Glue along the two sides as shown in the photo.
Guide step 24
24
Close. Attach a ribbon in the top, insert a note into the pocket if you wish and your tag is now ready to be inserted into the pocket on the front of the card.

Producten kopen

Prijs van het idee: € 0,00

Incl. BTW