Flessenopener met katoendraad

#v12514

De hanger aan de flessenopener is gevlochten met katoenkoord. De houten letters worden tijdens het macrameen toegevoegd. Werk af met ronde, houten kralen.

#v12514
Selecteer producten bij dit idee

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Totale prijs
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

Guide step %d
1.   Double over a long and a short piece of cotton twine and tie them onto the hole in the handle of the bottle opener. Arrange the two short pieces in the middle and braid around these with the long pieces of cotton twine. See the technique below.
Guide step %d
2.   Thread beads onto the two middle pieces of twine.
Guide step %d
3.   When the desired length is reached, finish with beads and knots
Guide step %d
A.   Braiding Technique: A clip board is used for starting and supporting the braiding. Attach the pieces of cord under the clip. Thread beads onto the middle piece of cord.
Guide step %d
B.   Follow steps B to I. Start again and switch from right to left until the desired length is reached.
Guide step %d
C.   -
Guide step %d
D.   -
Guide step %d
E.   -
Guide step %d
F.   -
Guide step %d
G.   -
Guide step %d
H.   -
Guide step %d
I.   -
Guide step %d
J.   Push up the beads when they are needed.
Guide step %d
K.   Place the middle cords parallel and braid an extra piece of cord over the two middle cords.
Guide step %d
L.   Cut off the ends leaving approx. 1cm.
Guide step %d
M.   Melt the ends one by one with a lighter and immediately push them into the braided piece with a pair of scissors (for example) so they melt together.
Al aangemeld? Download de sjabloon
Copyright © Creativ Company | 2021-present