Haarspeld gedecoreerd met kralen

Haarspeld gedecoreerd met kralen

Inspiration: 15471

Van: € 2,96

Tot: € 83,13

Prijs van het idee: € 0,00

Incl. BTW

Beschikbaarheid: Op voorraad

Van: € 2,96

Tot: € 83,13

Deze haarspeld is gedecoreerd met kralen die zijn genaaid met sieradendraad in een bloempatroon.
Guide step 1
Step 1.
Cut a 110 cm piece of jewellery wire. Thread four beads (4 mm diameter) onto the jewellery wire using a beading needle and assemble them into a ring. Feed the needle through the first bead and pull the beads together.
Guide step 2
Step 2.
Feed the needle through the other three beads and tie the two ends together with two or three knots.
Guide step 3
Step 3.
Tie the beads onto the barrette through the hole and around it as illustrated in the photo (seen from the back of the barrette). Tighten the wire firmly.
Guide step 4
Step 4.
Continue on the front of the barrette. Thread three small 4 mm beads and one large (5 mm in diameter) bead onto the wire. Push the needle through the bead on the left as illustrated in the photo.
Guide step 5
Step 5.
Now thread three small beads onto the jewellery wire and push the needle through the lower bead as illustrated in the photo. Tighten and secure at intervals by sewing underneath the barrette.
Guide step 6
Step 6.
Now make a flower with one large and seven small beads. On the left side of the flower there are two beads in a line. Push the needle through both beads. Thread two small and one large bead onto the jewellery wire and push the needle through the outer bead. Add another three small beads like in step 5.
Guide step 7
Step 7.
Make a total of six flowers each consisting of seven small and one large bead. You will need three small and one large bead for every other flower, meaning that each flower always consists of seven small beads.
Guide step 8
Step 8.
Finish with three small beads around the bead at the very left like at the start of the pattern.
Guide step 9
Step 9.
Push the needle and wire underneath the stitching (underneath the barrette) all the way to the opposite end of the barrette. Tie knots with the two wires. Apply a blob of glue onto the knot and trim the ends.
Step 10.
Template
Attached file: Download hier

Producten kopen

Prijs van het idee: € 0,00

Incl. BTW