Flessenopener met katoendraad

Flessenopener met katoendraad

Inspiratie: 12514

Van: € 14,28

Tot: € 85,67

Prijs van het idee: € 0,00

Incl. BTW

Beschikbaarheid: Op voorraad

Van: € 14,28

Tot: € 85,67

De hanger aan de flessenopener is gevlochten met katoenkoord. De houten letters worden tijdens het macrameen toegevoegd. Werk af met ronde, houten kralen.

Hoe werkt het
Guide step 1
1.
Double over a long and a short piece of cotton twine and tie them onto the hole in the handle of the bottle opener. Arrange the two short pieces in the middle and braid around these with the long pieces of cotton twine. See the technique below.
Guide step 2
2.
Thread beads onto the two middle pieces of twine.
Guide step 3
3.
When the desired length is reached, finish with beads and knots
Guide step 4
A.
Braiding Technique: A clip board is used for starting and supporting the braiding. Attach the pieces of cord under the clip. Thread beads onto the middle piece of cord.
Guide step 5
B.
Follow steps B to I. Start again and switch from right to left until the desired length is reached.
Guide step 6
C.
Guide step 7
D.
Guide step 8
E.
Guide step 9
F.
Guide step 10
G.
Guide step 11
H.
Guide step 12
I.
Guide step 13
J.
Push up the beads when they are needed.
Guide step 14
K.
Place the middle cords parallel and braid an extra piece of cord over the two middle cords.
Guide step 15
L.
Cut off the ends leaving approx. 1cm.
Guide step 16
M.
Melt the ends one by one with a lighter and immediately push them into the braided piece with a pair of scissors (for example) so they melt together.

Producten kopen

Prijs van het idee: € 0,00

Incl. BTW