Christmas card- step by step

Christmas card- step by step

Inspiration: 1269

Van: € 1,57

Tot: € 178,35

Prijs van het idee: € 0,00

Incl. BTW

Beschikbaarheid: Op voorraad

Van: € 1,57

Tot: € 178,35

Guide step 1
1
Cut a piece of red cardboard (9,5x 19cm). Fold at the middle and punch a heart in the lowest right corner.
Guide step 2
2
This is how the punch and placing looks like.
Guide step 3
3
Take the back cover of the paper lace border and pull it thru the heart.
Guide step 4
4
Punch a heart in white mother of pearl paper.
Guide step 5
5
Cut at piece of mother of pearl paper size 4 x 8,5cm (place the heart with a 1 cm margin to the top edge, and 1½ cm to the right and to the left edge).
Guide step 6
6
Then add the mother of pearl piece to the card with double-side adhesive tape.
Guide step 7
7
Pull the checked ribbon thru the white heart and fasten with double-side adhesive tape.
Guide step 8
8
Make a hole with a needle, and add the brad.
Guide step 9
9
Cut a piece of white cardboard (9 x 9cm) and put it on the back side of the card with double-side adhesive tape.
Step 10.
Tip: Give the punches a 3D effect by lifting the arches of the heart a little bit up from the card.
Christmas card with a tree
Guide step 12
1
Punch the border in stars out of the card front side.
Guide step 13
2
Cut a piece of music notes vellum paper (10, 5 x 20cm). Fold at the middle.
Guide step 14
3
Glue the music notes vellum paper on to the card with double-side adhesive tape.
Guide step 15
4
Cut 2 squares. One in red cardboard (6,5 x 6,5cm). And one in white mother of pear (4 x 4cm).
Guide step 16
5
Glue the paper lace border on the backside of the red square.
Guide step 17
6
Then glue the 2 squares onto the card with double-side adhesive tape. The red first and then the white.
Guide step 18
7
Punch a Christmas tree out in 2 sizes and 2 colours with the paper punches.
Guide step 19
8
Add the largest Christmas with double-side adhesive tape and the small one with 3D pads.
Guide step 20
9
Tie a little piece of checked ribbon around the legs of the brad. Make a hole with a needle and put the brad thru.
Guide step 21
10
Cut a square in red cardboard (12,5 x 12,5cm ) and glue it on the back side of the cards front side with double-side adhesive tape.

Producten kopen

Prijs van het idee: € 0,00

Incl. BTW