Macramé armband met cabochon

#v15464

Maak deze macramé armband van katoenkoord en een cabochon hanger in het midden. De armband is gesloten met een macramé sluiting en eindkappen.

Selecteer producten bij dit idee

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Totale prijs
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

Guide step %d
1   Cut a 90 cm piece of cotton cord. Thread a jewellery pendant with two loops onto the cotton cord as shown in the picture.
Guide step %d
2   Secure the glass cabochon jewellery pendant on the clip board and start braiding. Make a knot by placing the two cords as shown in the picture so that they form an reverse teardrop shape.
Guide step %d
3   Take the cord on the right and place it underneath the teardrop and over the cord on the left. Now take the cord on the left and place it over the teardrop and underneath the cord on the right. This picture shows what the knot looks like just before tightening the cords.
Guide step %d
4   Here is the knot made with a thicker cord to better illustrate the technique.
Guide step %d
5   Keep braiding following the procedure described in step 3. When the braided section measures approx. 6.5 cm, repeat the procedure on the opposite side of the glass cabochon jewellery pendant.
Guide step %d
6   Arrange the 2 x 2 cords parallel with each other. Cut a new piece of cotton cord for the macramé fastening described in steps 7-11.
Guide step %d
7   The four parallel cords are equivalent to the middle cord in the next two steps.
Guide step %d
8   The first knot.
Guide step %d
9   The second knot.
Guide step %d
10   Repeat these two knots till the braided section measures approx. 2.5 cm. Cut off the ends, leaving approx. 1 cm.
Guide step %d
11   Melt the ends with a lighter and immediately push them into the braided section.
Guide step %d
12   Apply Super Glue to the 2 x 2 cord ends and leave to dry. Cut the cord ends diagonally and thread on crimpy beads tubes. Apply glue onto the cord where you want to position the crimpy beads tube and slide it over the glue. Leave the glue to dry and then trim the cord ends.
Al aangemeld? Download de sjabloon
Terug
Ik ben aan het winkelen als
Ga verder als guest
Uw voordelen van inloggen

✔ Uw persoonlijke verlanglijstje

✔ Bestelgeschiedenis bekijken

✔ Eenvoudig afrekenen
Uw voordelen van inloggen

✔️ Speciale prijzen

✔️ Speciale B2B-producten

✔️ B2B-marketingdomein
Uw voordelen van inloggen

✔ Content speciaal voor u

✔ Speciale prijzen
Copyright © Creativ Company | 2021-present